Hi list, I have to start doing some multicast on my backbone. As a 1st step I want to do a basic setup using PIM-DM. I currently have: stream-server 6509 Juniper 6509 PC it's the same 6509 on 2 different vlans and IGMP is enabled on the 6509. I tried to do some basic igmp/pim configuration and it still doesn't work. I know that the streaming via multicast works because when I put my pc on the same vlan I get the streaming fine via the multicast feed. Multicast trace hop-by-hop using the mtrace command. Show ip mroute count. Show ip mroute active. Debug ip mpacket. Check Receiver Signaling. Complete these steps to check receiver signaling: Use the show ip igmp groups command at the first upstream router connected to the receiver to check that the interface has joined the group. I was just wondering if any of you guys had a simple config for that kind of setup. I'm also wondering if I need a TS PIC. From what I read, I will only need it when I start doing PIM-SM. The router is receiving: Sep 22 11:23:58 IGMP RECV *.*.*.* -> 224.123.123.102 V2 Membership Report: group 224.123.123.102 length 8 but nothing happens afterwards. You are correct. A TS PIC is not needed for PIM DM. Perhaps some configuration snips from the Juniper and the OP of show pim interfaces commands would get things rolling? Regards > -----Original Message----- > From: [email protected] > [mailto:[email protected]] On Behalf Of > Christian Malo > Sent: Wednesday, September 22, 2004 8:27 AM > To: [email protected] > Subject: [j-nsp] Multicast configuration > > Hi list, > > I have to start doing some multicast on my backbone. As a 1st > step I want to do a basic setup using PIM-DM. > > I currently have: > > stream-server 6509 Juniper 6509 PC > > it's the same 6509 on 2 different vlans and IGMP is enabled > on the 6509. > > > I tried to do some basic igmp/pim configuration and it still > doesn't work. > I know that the streaming via multicast works because when I > put my pc on the same vlan I get the streaming fine via the > multicast feed. > > I was just wondering if any of you guys had a simple config > for that kind of setup. > > I'm also wondering if I need a TS PIC. From what I read, I > will only need it when I start doing PIM-SM. > > > The router is receiving: > > Sep 22 11:23:58 IGMP RECV *.*.*.* -> 224.123.123.102 V2 > Membership Report: group 224.123.123.102 length 8 > > Holley pro jection 4 manual. but nothing happens afterwards. > > > -chris > _______________________________________________ > juniper-nsp mailing list [email protected] >.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |